Order of jobs when fitting bathroom

I would advise tiling as much as you can before installing the suite. Tiling under the toilet and sink ensures more protection and a better seal.

Strip out bathroom. Pop in pipework. Tile it. Fit new suite

First time must be started with the removal of the sanitary parts, then the tiles, pop in new pipework if required, the walls and floors are straightened, pop in shower tray the new tiles and at the end the basin and toilet

1.Demolition. 2.First fix plumbing and electrical depending on the condition. 3.Plaster boarding walls and ceiling. 4 Plywood or duramatt on the floor. 5.Tilinng 6.Grauting. 7.Suite instalation 8.Second plumbing and electrical fix. 9.Clean up. 10.Silicones.

First you must remove the sanitary and tiles. Do the first fix of plumbing. Then check the walls, if the walls are weak you must replace them with a cement board. After that fit the bath (or shower tray), seal it (so there won't be any leakages). Start laying the tiles, you can either tile the whole bathroom or only tile around the bath and half of the wall where the sink and toilet are. Also do the silicon around the bath, around the basin and around the toilet