Skip to main content

Ready to hire?

Post your job in minutes, browse real reviews and choose who to speak to.Post a job

Need some tips or advice?

Ask a question
Gas Works

Building regulations and where System boiler is fitted

Anonymous user 23/02/2024 - 3.24 PM

I am planning to have a Vailiant 637 boiler installed in a kitchen. The boiler will be fixed at the rear onto a solid external brick wall. Once the boiler is fitted, a cabinet will be built around it, bearing in mind the internal clearances recommended by the manufacturer. Question is? can this boiler within a cupboard, sit adjacent to a glass sliding door, as boiler being located in corner of room - where back of boiler will be attached to brick, but the side panel of the boiler (housed within a cabinet) will be against a sliding glass door panel that moves open/closed. Is this permissible from a building control perspective? Or do both corner walls where the boiler will sit (within a cupboard), need to be brick? My Architect seems to think so. Please clarify Thanks

Are you a tradesperson and able to answer this question?

5 Answers

Boiler Homecare

Rating: 5 out of 5
Honiton
I think a more sensible and less confusing answer would be to invite a Gas Safe engineer who has many years of experience to attend and discuss the proposed location of the boiler with him then listen carefully to his advice or if you wish invite another for a second opinion too!
Answered1 June 2019
7

SK Gas

Rating: 5 out of 5
Stockport
As long as the sliding door panel does not interfere with the boiler, you can.
Answered8 June 2019
1

Expert Heating Scotland Ltd

Rating: 5 out of 5
Glasgow
If the boiler is in a cupboard and all clearances are to manufacturers instructions the sliding door shouldn’t matter.
Answered8 June 2019
1

rjm plumbing & gas ltd

Rating: 5 out of 5
Hull
Providing that the specific manufacturers clearances are followed regarding the boiler in the cupboard and the flue clearance is the correct distance externally from the sliding door then there won't be any problems.The new boiler is room sealed so unaffected from drafts etc.
Answered8 June 2019
1

SM Heating & Plumbing Services

Rating: 4.9 out of 5
Renfrew
The Building Regulations are designed to ensure new buildings meet health, safety, welfare, convenience and sustainability standards. They relate to the specifics of how a building should be constructed unlike planning permission which is about the principle of whether development should go ahead or not. Many jobs in the home need to be notified to and approved as being compliant with Building Regulations by a Building Control Body, either your Local Authority Building Control or a private sector Approved Inspector, unless carried out by installers registered with a Competent Person Scheme who can self certify that their work is compliant. Some examples of notifiable work (not a complete list) are shown below. Those marked * may not need to be notified in certain circumstances. What will happen if I do not comply with the Building Regulations? • If you do not comply the work will not be legal. You could be prosecuted and could face unlimited fines. • The work may not be safe, could cause health problems, injury or even death. It may also not meet energy efficiency standards. • If work is found to be faulty your Local Authority could insist you put it right at your own expense. • If the work has not been notified to a Building Control Body or carried out by a Competent Person Scheme registered installer the Local Authority will have no record that the work complies with Building Regulations. These records will be important when you come to sell your home as you may be asked to provide certificates of compliance with the Building Regulations. Why should I use an installer who is registered with a Competent Person Scheme? • An installer registered with a Competent Person Scheme is qualified to carry out specific types of work in accordance with Building Regulations and should both notify the local authority of the work and issue you a certificate of compliance with Building Regulations either directly or through their scheme operator. If you do not receive a certificate within 30 days of completion contact the Competent Person Scheme operator that your installer is registered with and they may be able to help you resolve this. • If you do not use an installer registered with a Competent Person Scheme then you will have to submit a building notice or full plans application and pay a fee to have a Building Control Body come and inspect the work you have carried out. • You will be given financial protection to cover the event of non-compliant work being found where the installation company has gone out of business Visit www.competentperson.co.uk or for electrical work you can visit www.electricalcompetentperson.co.uk and enter your postcode or the name of the installer in the relevant search box. Competent Person Scheme operator contact details and the types of work each operator covers are at the end of this booklet. How can I find an installer registered with a Competent Person Scheme in my area or check that my chosen installer is with a scheme? Please see below for examples of work that you do or do not need to notify to a Building Control Body before starting. Please note that these lists are not complete and there will be other work not listed here that you will need to notify. If you are in any doubt you should contact a Building Control Body for advice. Some examples of work that you DO need to tell a Building Control Body about unless you use an installer who is registered with a Competent Person Scheme. • installation of a new or replacement heating system or boiler, regardless of fuel type • installation of a new or replacement oil tank • installation of a bathroom if new plumbing is installed or existing plumbing is altered • installation of a fixed air conditioning system • addition of a radiator to an existing heating system (may not need notifying in some circumstances) • installation of a new or replacement fuse box (or consumer unit) or any new electrical circuit connected to the fuse box, and alterations to electrical installations around a bath or shower • replacement of window and door units • replacement of roof coverings on pitched and flat roofs Some examples of work that you DO NOT need to tell a Building Control Body about but you can still use a Competent Person Scheme registered installer. • most repairs, replacements and maintenance work (except replacements of combustion appliances, oil tanks, electrical fuse boxes or glazing units, which do need to be notified) • additional power points or lighting points or any other alterations to existing electrical circuits (except around baths and showers) • like-for-like replacements of baths, toilets, basins or sinks Below is a list of the types of work covered by Competent Person Schemes. The scheme contact details are overleaf. Installation of cavity wall insulation: Blue Flame, Certass, Certsure, CIGA, NAPIT, STROMA Installation of solid wall insulation: BBA (including hybrid), Blue Flame (including hybrid), CERTASS, Certsure (including hybrid), NAPIT (including hybrid), STROMA Installation of gas appliances: Gas Safe Register Installation or replacement of hot water and heating systems: APHC, Benchmark, BESCA, Blue Flame, Certsure, Gas Safe Register, HETAS, NAPIT, OFTEC, and STROMA Installation or replacement of oil-fired boilers and storage tanks: APHC, Benchmark, BESCA, Blue Flame, Certsure, NAPIT, OFTEC, STROMA Installation or replacement of solid fuel burners: APHC, BESCA, Certsure, HETAS, NAPIT, OFTEC, STROMA Installation of fixed air conditioning or mechanical ventilation systems in dwellings: BESCA, Blue Flame, Certsure, NAPIT, STROMA Any electrical installation work in dwellings: Benchmark, BESCA, Blue Flame, BSI, Certsure, NAPIT, OFTEC, STROMA Electrical installation work only in association with other work in dwellings (e.g. kitchen installations, boiler installations): APHC, Benchmark, BESCA, Blue Flame, Certsure, NAPIT, STROMA Replacement windows, doors, roof windows, or roof lights in dwellings: ASSURE, Blue Flame, BM TRADA, BSI, CERTASS, Certsure, FENSA, NAPIT, STROMA Installation of plumbing and water supply systems and bathrooms and sanitary ware: APHC, Benchmark, BESCA, Certsure, HETAS, NAPIT, STROMA (except for wholesome cold water supplies) Replacement of roof coverings on pitched and flat roofs (not including solar panels): CompetentRoofer, NAPIT Installation of microgeneration or renewable technologies: APHC, Benchmark, BESCA, BRE, Certsure, HETAS, NAPIT, OFTEC, STROMA These schemes have been listed alphabetically. This does not reflect the size of the scheme or whether the scheme specialises in dealing with a particular type of work. Visit www.competentperson.co.uk to see if there are members in your local area who undertake the type of work that you are interested in. If you want electrical work done then you can also visit www.electricalcompetentperson.co.uk to search for members. APHC www.aphc.co.uk 0121 711 5030 Certsure LLP (trading as NICEIC) www.niceic.com 0870 013 0382 Benchmark Certification www.benchmark-cert.co.uk 0238 0517 069 BESCA Blue Flame www.blueflamecertification.com 0845 194 9031 www.besca.org.uk 0800 652 5533 BM Trada www.bmtrada.com 01494 569 700 BSI www.kitemark.com 0845 0809 000 CERTASS www.certass.co.uk 08450948 025 CIGA www.cwisc.org 01525 853300 Certsure LLP (trading as ELECSA) www.elecsa.co.uk 0333 321 8220 FENSA www.fensa.co.uk 020 7645 3700 Gas Safe Register www.gassaferegister.co.uk 0800 408 5500 HETAS www.hetas.co.uk 01684 278170 NAPIT www.napit.org.uk 0345 5430330 Network VEKA (ASSURE) www.networkveka.co.uk 0800 80 00 80 Competent Roofer (NRFC) www.competentroofer.co.uk 020 7638 7663 OFTEC www.oftec.org.uk 0845 658 5080 STROMA www.stroma.com 0845 621 1111 British Board of Agrément (BBA) www.bbacerts.co.uk 01923 665 386
Answered1 June 2019
0