Skip to main content

Ready to hire?

Post your job in minutes, browse real reviews and choose who to speak to.Post a job

Need some tips or advice?

Ask a question
Restoration & Refurbishment

Front of house rendering that crumbles away?!

Anonymous user 23/02/2024 - 3.16 PM

Hi there, any advice appreciated... Got some guys to remove stone cladding and pebbledash and render the front of my house 2 months ago. They seemed to do a very nice job and it looks great. However, today I was going through my side gate bringing a bit of a wood, and the wood caught the corner of the house/render, and quite a considerable bit (ten pound note size) came away.The bit that came off in my hand I could crumble to pieces in my hand. On closer inspection of the corner, I could see that at some points the render was slightly 'over' the edge of the house/bricks, which would explain why I caught a bit as I passed (and perhaps explain why a bit came away). Where it came away, I ran my finger over the exposed area as it's pretty crumbly. I also ran my finger vertically up and down the corner and most of it was tough/concrete like, but some of it was dusty/crumbly. Went around the front of the house, knocking on it and inspecting for damage, and there doesn't seem to be any issue. So....sign of a general issue with the rendering, or just a 'catchy' corner and a weak bit?

Are you a tradesperson and able to answer this question?

2 Answers

GP ELECTRICAL AND PLASTERING

Rating: 5 out of 5
Ashford, Kent
When I read the title of this it sounded like your render had blown (you know when you tap a wall and there’s a patch that sounds slightly hollow), but upon further reading I would say that what SEL has said is quite likely. My best advice would be to call the guys that did it and ask them to come back to rectify the problem.
Answered20 June 2019
1

Anonymous user

It is the usual practice to put external angle beads on for finishing the rendering to on the external corners. This of course will provide the solidity needed on the external corners. So either patch repair and leave as it is / live with the problem or hack off all the external corners, put the beads on and re-do rendering onto the beading
Answered20 May 2018
0