Skip to main content

Ready to hire?

Post your job in minutes, browse real reviews and choose who to speak to.Post a job

Need some tips or advice?

Ask a question
Roofing

Help - New Flat Roof Advice - Pooling Water at Edge

Anonymous user 23/02/2024 - 3.04 PM

Hi, Advice very very much appreciated. We have a brand new dormer roof. There is a slope / fall so the water runs but then pools at the very bottom of the fall and is standing there as there is a small lip at the bottom of the fall. The builder / roofer tells me this is normal and no problem. He says that this is the best they can do as the lip along the edge of the roof effectively has to be there due to the fact there are additional layers of felt here to join and seal where the wall effectively meets the roof. So although there is a fall and water runs off some will get stuck here and can't be helped. I am unsure as i thought any standing water on a new roof was a bad idea. I don't know whether we should be insisting this is corrected so all the water runs off. Or whether this is the best we can hope for. it seems strange to me to have water running down and then pooling there. why bother with the run off at all? Thanks a lot in advance for helping me when unsure if i can take the person who has done the work at face value.

Are you a tradesperson and able to answer this question?

3 Answers

Anonymous user

If the flat roof in question is brand new then there shouldn't be any water pooling in any areas, least of all at the lower end of any fall. If the fall is correct all water should fall towards the guttering. You can occasional get slight pools of water that wouldn't cause an issue so it would depend on how much water is there.
Answered4 August 2016
1

A&J Surveyors Ltd

Rating: 5 out of 5
Newent
Even with a couple of layers of drip, water should not really pool at the bottom of a slope.... I would question what works was carried out. If your roofer left the old deck in place then it maybe that the old boards are swollen at the bottom of the fall causing a ponding area. On my fibreglass roofs you normally have a 1-2mm raised lip along the gutter line but generally this does not pond if there is a slope.....something is not quite right.....
Answered4 August 2016
1

Swift Shift Roofing Solutions

Rating: 5 out of 5
Waltham Cross
It sounds like the two be 2/1 batten is sitting too high on front edge of gutter line so when you do your drips the Felt you are pulling over is sitting that bit high and when you lay your top mineral cap layer it may incur a lip on the front edge which in turn will make it Pond but if the drips are done right can't see it being a problem hope this helps 👍
Answered21 August 2016
1