Job description

• Rewiring
• Owns the property

Customer description

We have purchased three CCTV cameras that utilise the Power System to transfer data - as well as provide power. They work through a Master parent plug connected to the Router and then three child plugs inside the house leading out to each camera.

They work at the moment. However, we have had advice that there is an improvement in quality IF each of the child sockets also operate on the same ring main as the master socket. At present, the master is on the lower power ring, and two of the cameras (I suspect but needs confirming) operate on the upper power ring.

I would like to remedy this and run NEW power cables from the lower master socket to all the cameras ( note - the third camera should be no issue - it is already there).

One should be relatively simple as it runs directly from the garage wall outside. The one at the back of the house however may need something more creative.

Clearly security is the issue so any cabling needs to be internal and protected.

Hope that is all clear!! 😀😀