Fit combi boiler, pump and flue - Gas Work job in West Molesey, Surrey

Job description

I have an old (15 years +) Baxi boiler with separate hot water cylinder + cold water tank. Live on the 3rd floor of a block. Flat is all on one level, approx 550 sq feet (2 bedrooms, 5 rads) Looking to replace the existing system with a combi condensing system (Valiant, Potterton or Worcester / Bosch). Looking to move the boiler from bedroom to kitchen - will require a new flue. All existing rads are fine, but have individual thermostats not central controls. Have been advised that water pressure is low in block so would need a pump or similar. I want to get rid of the hot and cold water tanks to save space. Need a small combi (to fit in space approx 16" wide) To be completed asap Please break down quote to include parts, labour, VAT (if applicable)and warrantees.

Feedback

Feedback for T.M.S.Gas and Heating Services

There are a lot of positives to write about Tarek; he is likeable, hardworking, very knowledgeable and provided an extremely competitive quote.

For the duration of the job Tarek worked long hours solidly through the weekend, and turned up even when transport ground to a halt through the snows. He was also ok to come back after work was finished to rectify several items.

However I find it hard to fully recommend him because the finish of the work was very poor; the making good of a flue has left my wall finish uneven...I had to remove his boxwork as it was crooked. There are some unnecessary sections of piping left on wall and requested electrical work was not completed. Where drilling was needed to change pipes, the holes were left gaping or clumsily filled with cement. Also my cooker is no longer flush to the wall unit.

A hardworking and knowledgeable plumber, but I would suggest you think twice if any intricate pipework is required.

T.M.S.Gas and Heating Services's reply:

Customer stated he was happy with the job. He did not raise any issues with me.Had he had done so I would have rectified them. The electrical work was unrelated to the boiler installation. Customer did not wish to proceed. The hob was unsafely connected to gas supply I changed this to comply with corgi safety standards,taking two and a half hours,free of charge.