Electrical jobs in Streatham Hill, South London

Job Description

Hi
At present the light in my bathroom is operated by a pull switch from the ceiling. I would like to change this to a normal switch on the wall. My ceiling light is a bathroom compliant ceiling globe, so no worries there. The bathroom is also fully tiled. Could you please give an estimate for this job.

Job Description

I am currently levelling and reflooring a bedroom and thought while the floors were up i'd see if i can get additional sockets installed.

This should be a quick job but would need to be done this week preferably.

This is likely to lead to further work as I am planning on installing a kitchen, bathroom, floors in other rooms, an outdoor tap, moving radiators (or possibly installing underfloor heating) and possibly installing a skylight over the next few months.

Job Description

I would like one double wall socket fitted inside a closet. There are electrical spurs already in the closet feeding an alarm and phone panel and there is a double wall socket on the opposite side of the wall where I would like the socket installed.

* Added 21st May, 2013 :
If you have plumbing skills too, I also need a pump replaced under my bath but this is not urgent so please do quote for the above electrical work if you do electrical work only.

Job Description

A newly built small office space with a kitchen area and seperate open space with about 4 power points downstairs and an open space with about 4 power points upstairs.

Ideally the space downstairs needs to house 7 desks, and so requires additional power outlets for computers.

The space upstairs ideally needs to run on a separate circuit, not a separate meter, just a circuit, so if a fuse trips it wont cut off the electricity for downstairs.

Job Description

I need someone to help convert wall lights in the living room and 2 bedrooms into "downlights" (spotlights).

The floorplan of the flat can be found here (http://www.dundeewharf.com/plans/index.shtml?typeb.inc)

Job Description

Fit 2 LED light bulbs sockets in the bathroom (for GU10 light bulbs)
(See picture attached, we'd like to have this replaced with a standard GU10 socket)

Job Description

My bathroom light will not turn on. It would appear it is simply a loose connection or the switch is broken.
A quote for time would be appreciated.

Job Description

Hi,

We are looking for someone who can connect our new cooker. The cooker is a Leisure GRB6CVK-BK 60cm freestanding cooker and requires a HO5W-FG5 x 1, 5mm2 / 3 x 4mm2 cable which was not supplied. We also require a ceiling light fitted which does not attach to the original light fitting. We are happy to call to discuss.

Availability before 10.30am or after 6pm preferred.

Thanks, Kerry

Job Description

I currently have one of the 2D 4pin lamp fittings type B in my bathroom where when the light switch cord is set to the on position it make the lamp turn on and the extraction fan at the same time.

I have changed bulbs before without any problems once they have had their lives worth but This time I have changed the bulb and the light still does not turn on fully. I thought maybe it was a faulty bulb so purchased another and still it has made no change. The light only partly comes on at the start of the two tubes of the 2D lamp but does not come on fully as it should. The extraction fan still comes on as it should.

The job I would like to request is take the exact same light fitting from the balcony and replace the bathroom fitting with this, or to repair the current fitting if it is possible.

Job Description

Supply and install new electrical distribution board with RCD protection. Issue electrical installation certificate.

Install 2 gang mk dimmer or a trailing edge dimmer

EICR report

PAT and gas safety certificates

Job Description

I am looking for quotes on the potential wiring and installation of approximately 9 recessed ceiling lights in a kitchen ceiling of a two bed house victorian house in walthamstow. I would also like to install a pendant lamp in the same room above a breakfast bar. Ideally both pendant and recessed lights would be on separate dimmers.

The job would involve taking down the existing lights which are suspended on wires across the length of the ceiling before installing new lighting.

I am interested in whether the tradesman would have to carry out the work by going in through the floor above (to avoid joists etc) or be able to execute the wiring and installation from the kitchen. Minimal disruption to the home would be preferable, but equally id like to avoid a ceiling that ends up looking like a pepper pot. Ideally quotes would include the estimated cost of fixtures and installation.

many thanks.

Job Description

We are looking for two things to be done, namely -
- change a light fitting in the hall
- input a light fitting (spot light) and with in the cloak room - no fixtures for lighting in their at the moment.

Job Description

Removal of a small, old Dimplex bathroom wall heater to be replaced with the installation of a Knightsbridge Mirror Light c/w dual voltage shaver socket (Model RCTM2T8). Existing wire to old heater may need lengthening as possibly located in the wrong place for the mirror light.

Job Description

the fire alarm keeps beeping continuously, preventing us from sleeping, this needs to be fixed ASAP.

Job Description

Large Studio in a Converted Church (pre-1900) has lots of lights that need replacing. They are about 15 feet high, above a wooden, sprung floor. They include several flood lights that I believe need new ballasts and possibly bulbs and a selection of other lights. Materials would all need to be bought as well.