Electrical jobs in Manchester, Lancashire

Job Description

Out house was built in 1980 and has the original consumer unit installed, which still has wire!
The CU and tails are in the garage, and has
4x 32 rings
2x lighting rings
1x CH
1x Cooker

I need:
1 - The CU changing over to one that is up to code (and has a few sape ways after the new ring is instaleld
2 - A new 32A ring installed in garage with 6x doubles, 2x switched fused spurs
3- 1 socket installed below the CU that can be used for an arc welder.

I need a quote. and the work doing before 16th December.

Job Description

zanussi built in cooker zdf290x heating element not working.
The light and fan working fine.

Job Description

Requires replacement of 30A hardwired supply with 13A socket, otherwise straightforward oven replacement. Also disposal/recycling of old oven.

Job Description

I've just moved into a house and before I start decorating I want to check the electrics in the house and the electric meter needs tidied up as it's in the living room.

Job Description

i need electrician for periodic testing, and for the electric to meet the health and safety standards, not the current standards.

Job Description

My oven electric oven recently stopped working and I would like a qualified electrician to see if it can be repaired.

Job Description

Hi,
I require two 3-way light switches (currently placed right next to each other) to be relocated about 1500mm away along with a single plug socket. My upstairs toilet is currently still separate from the bathroom and I plan knock through and reinstate the doorway to combine into one room and therefor the switches etc need to be moved so they are not inside what will be the bathroom.

The cables run up from the switches into the loft and feed lights in the bathroom, toilet, landing, loft and exterior security lights.

Cheers,

Al.

Job Description

I have a cooker hood that has not been working for some time.
The model is:
Firenzi INT-916/GY

Job Description

Hello, we are in the process of purchasing a 3 bedroom semi detached house in South Manchester. The house requires a full re-wire and we would like to obtain a quote for the work required. The keys can be collected from the estate agents if required, please email me for further details. Many thanks.

Job Description

All it is is I have bought a new electric cooker and moved in a new flat. I was going to wire it myself but the instruction booklet to wire it is vague so I dont want to do it the wrong way and melt my cooker, it should only take a matter of minutes and I am on a very strict budget so would welcome any offers

Job Description

Upstairs sockets and boiler on a single fuse need fixing. Woold also like general wiring test/appraisal on house we have just moved in to in Salford.

Job Description

Electric shower is broken. Gainsborough 10.5 SE.

The shower first dribbles cold water, then sounds as if it is boiling and hissing, sprays strongly with very hot water, the hissing sound subsides and the water pressure drops and goes cold - This repeats until the shower is turned off.

We would like someone to come round and give us a quote on the problem and how much it would be to fix.

Job Description

There is a modern consumer unit in the property (terrace, circa 1900), but there are not enough electrical points and most of them are the older style sockets that need changing. We need three new sockets installed; one in lounge, one in hallway and one in bedroom. Change out the old style light fittings and electrical sockets for modern ones. Install a shaver socket in the bathroom and remove an electric heater and defunct shower switch.

Job Description

Remove built under single oven (dead) which is a plug in one and replace with a built under double oven which will need hard-wiring (?). The new oven (not ordered as yet) will be approx 2cm higher than the curent oven so the kitchen skirting will need to be reduced accordingly at the oven bit.

Job Description

I am planning to have a new kitchen installed and wanted to add some new sockets at counter height.
There are also 2 sockets at floor level, not sure if these would necesarily need to be removed or could just be left.

I would need 3 x new worktop height double sockets, and also a resite of fuse and socket box for the cooker switch
Thanks