Electrical jobs in Rochester, Kent

Job Description

change electric light switches

Job Description

I have a ceiling mounted 16w 2D light fitting and the wiring to the block the lamp plugs in to has come loose/snapped out. Therefore, I need a new block fitted please. The lamp is a 2 pin CF type (16W/835/2P).

Job Description

I have only one socket in an upstairs bedroom which must be part of a ring circuit. I wanted to run a stud socket off of it but now realise I will also have to have a condensation control unit (maximum power 7.4w) run off of it as well. Can I run a stud socket off of the main socket, then run another line off of the main socket? (I don't think it's possible to run another stud off of a stud)... Or is it possible to split the line run off of the main socket so it feeds the secondary socket and the condensation unit? I need for somebody to identify the best solution and carry out the work.

Job Description

I wish for a bedroom light (which has a fan attached to it) to be removed. In addition, I wish for an already purchased light (one light comprising 3 spotlights) to be put in its place.

Job Description

Need to fix a cooker socket in the kitchen

Job Description

Hi there I need some things doing around the house like chasing some plug sockets out an capping off some sockets they don't have to have paper work as I am getting the work tested on Saturday need to carry out the work before Saturday I reckon there is enough work there for a whole day

Job Description

We upgraded the fuse box in our house from an old wired one (1970?) to a new RCD unit. This was installed by a qualified electrician and unfortunately he is not in a position to help us further.

Since the fuse box was installed we're unable to have both the lights and power on at the same time. On the rare occasions that we can, the power will soon trip if something is plugged in. This can be anything from a hairdryer, microwave, kettle - it doesn't seem to matter. It can even trip as soon as you put both power and lights on together. We've tried different approaches, so lights in certain rooms turned off with power etc, but nothing really seems to make a difference.

We're led to believe that the former homeowner did his own DIY jobs on the electrics from time to time which could be a potential cause, but we're unable to locate the actual fault.

We've got into a system whereby we only have the power on and light supplied from power source each day- the lights are only ever on when we have a shower in the morning and the power is off (although we have a power shower which works without the power on?). Therefore there's no pressing urgency for this job to be fixed, but ideally within the next month or so.

We have a couple of other minor jobs around the house too.

Job Description

2 bedroom flat need check wires to found out
Lighting fuse blown frequently (once in 2-3 month).
2 wall plug no power supply. Rest OK.
Replace older wired fuse to a modern consumer unit if needed.
Certificate may be.
Any Monday will be ideally as I am off.

Job Description

Test electrical circuit, make safe any faults and issue certificate for a four-storey, 9 room former HMO which has been empty for three years. Visual inspection indicates wiring is modern and in good condition. There is one main distribution board and seven subsidiary consumer units.

* Added 11th November, 2011 :
Job deferred for a few weeks - will advise when ready to go ahead.

Job Description

EICR for a large 4-bedroom semi. 3 ring mains, 2 lighting circuits, cooker, shower, immersion.

Job Description

Supply and fit 6 downlights and supply and fit replacement extractor fan to ceiling (150). Extend power supply from existing rcd to new fused spur at opposite end of bathroom ready for connection to a steam/shower cabin (Cabin is fitted with its own rcd) Must be Part P certified

Job Description

Want some security lighting fitted to outside of our detached bungalow

Job Description

Troubleshoot and fix the electric cable running from my fuse board to the garage.

Job Description

Live in a 1926 property and need a full re wire plus extra sockets and connections for electric hob and ovens. Getting kitchen quotes until end January 2013. Need to re wire before getting kitchen installed. All inclusive quote please.

Job Description

Just bought and fitted a Creda Eco Response 500 storage heater. I've installed it as far as mounting it to the wall, fitted bricks etc, just need a sparky to come and do the wiring. We had an old storage heater that was wired in, so the off peak wiring is all in place (assuming this is suitable, the old heater was rated at 3.4kw, new one I think is 2.5). The main bit is the peak supply cable needs wiring in. The fuse box/meter is only on the other side of the wall, so needs a short bit of wire running through (all can be surface mounted) to a box. Probably an hours work at best?

Pete