Driveways jobs in Castleford, West Yorkshire

Job Description

68m2 of driveway which needs a new surface. Originally I was looking at Block paving but I understand there are also other resin based alternatives that will also look attractive. I am open to suggestions - Advice needed.
Thanks

Job Description

dig out and prepare then lay concrete drive 10m x 4m to take a timber workshop

Job Description

Driveway 18m long x 3.3m wide. Currently approx 100mm thick concrete to break out and remove. Replace with either suitable driveway gravel or Block Paving.

Job Description

Hi We are looking for quotes for driveway and patio. if you are interested pls call us for site view.we are looking for concrete base and the measurement for driveway is approx 11ftx60ft and patio is 11ftx11ft &7ftx8ft. Thanks

Job Description

Job 1. Remove existing small concrete driveway (approx size 4 x 3 meters) and replace with block paving

Job 2. Remove existing single wooden garage door and frame and replace with 'up-and-over' white-finished metal door (non-motorised). Approx opening size 7' 6" wide by 6' 10" high

NOTE:- I would be willing to consider quotes for either the whole job or separate quotes for either job 1 or job 2. All quotes to be fully itemised and include all labour, materials, and removal and disposal of all waste materials.

Job Description

bog standard, basic, cheap as possible driveway as its a council property and we just want to put cars in the front garden but needs a proper hardstanding.

The driveway is 7m by 4m but is sloped slightly.
The council have said it needs to be at least 4inch thick.

Can be Tarmac OR concrete - which ever is the cheapest haha

we had a guy come in and do this already, he started.... he removed a section of the wall to get cars in, then he hardcored it, and tarmaced HALF the garden and done a runner - not seen him since

quote to include labour and materials

Job Description

We would like our front, grass covered, garden, which is approx 10sq meters, to be converted into part of our driveway. The rest of the drive is block paved, however, we are not planning on doing to same to this, but need something that would not look out of place. (possibly tarmac)

Job Description

The job is to hang a set of driveway gates the posts are already in and just require the hanging brackets welding on these are also here and the gates levaling the width of the gap is 11ft from post to post and there is a slight slope from one end to the other but obviously the gates will need to be leval the gates are 5ft high.