Conversions - General jobs in Sandhurst, Berkshire

Job Description

i have two rooms and i am interested in taking down the internal non load bearing wall that divides them, also moving a boiler and making good ceilings & floors

Job Description

Remove wall between kitchen and dining room, block work fill arch/wood work between dining room and lounge. Fit steel to padstones over wall space between kitchen and dining room. Relocate radiator and electics and make good as appropriate. I have structural plans from a suitable surveyor/engineer.

Job Description

Garage Conversion; Converting the back third of my garage into a laundry room.

To complete: put up a wall to divide the garage, plumb in the washing machine, raise the floor to the level of hallway, tile the floor, 3 x double sockets, strip lighting, plasterboard and skim (not paint), and knock a door through into the hall of the house.

The address is Campbell Fields, Aldershot, GU113TZ.

Job Description

The partition between the kitchen and dining room of this 20 year old Bovis home approx 2.2 metres in length it to be partially removed leaving the lower half of the wall behind the kitchen cupboards. The door that divides the two rooms to go.

The lower part of the wall that contains kitchen cabinets is to stay and the work service extended to create a breakfast table allowing seating in the dining room. New kitchen surface exists for this job.

Finish and make good the ceiling and two walls.

Finish the floor where the wall is removed with tiles. New tiles exist to complete this task.

The finished product will be an open plan kitchen/diner with a breakfast bar where the wall existed. Access between the two areas will be a free and open space created by the removal of door and the wall up to the kitchen cupboards. A width of about 1.5 to 2 metres.

Job Description

TO PUT WALL IN A BEDROOM TO CHANGE IT INTO 2 ROOMS.
IT WILL NEED ELECTRICAL POINTS AND LIGHT AS WELL AS TO DOORS AND FRAMES

Job Description

Would like a partial wall between hall and lounge and a sliding door

Job Description

We would like to knock through our dining room into the garage - leaving the front of the garage as storage. The rear of the garage has already been converted into a room, but would need to be integrated into the existing dining room. We live in a Bryant Victoria home.

Job Description

A downstairs room has two sets of double doors on either side and I would like them removed and a stud wall put in their place. New electric sockets to be fitted at the time of construction. Possibility of the plasterboard ceiling being replaced at the same time.Two stud walls are about 2m x 3m. The ceiling is the same.

Job Description

We have a garage which is detached from our property which we wish to turn into a home office & hobby recording studio.

The garage is brick built and we would like to extend it out a little, increase the ceiling height, add a shower & wc. Soundproofing is essential.

I need a planner who can work with me to come up with some plans and take it through to gaining planning permission. I have knoweldge in soundproofing so will be able to guide as to what I need in that respect.

Job Description

We have 2 bedrooms that we would like turned into 3. The new bedroom will also need a window put in (planning not required just building regs). I would like our living room carpet taken up and laid in the new bedroom and a real wood floor laid where the carpet has been removed downstairs. We are also considering having a garage conversion or extension done so would like additional quotations for that too!

Job Description

To supply and fit French doors where we have a single door with a window. The wall under the window will need removing to fit double French doors.

Job Description

Following regularisation application and building regs inspection, the following works need to be completed on a garage conversion to achieve approval(extract from inspection report):

1. The room formed requires a window with an opening suitable for escape. The opening should have a minimum dimension of 450mm and the openable area should achieve 0.33m2. The bottom of the opening should not exceed 1100mm above floor level (B1). There is already a window in place, but the dimensions do not meet those stated above.

2. The radiator should be fitted with a thermostatic radiator valve (L1)

3. The external wall must achieve a thermal U value of 0.45W/m2k. If not already insulated to this standard, either cavity fill insulation or the application on the internal face of 25mm of a Celotex type insulation and plasterboard finish will provide this (L1)

4. The internal block partition between the room and the remaining garage/store must achieve a thermal U value of 0.6W/m2k. If not already insulated to this standard, the addition of 50mm of a Celotex type insulation and plasterboard finish on the garage side of the wall will provide this (L1).

* The internal partition wall is approximately 10ft wide by 7ft high.
* The external wall is approximately 10ft wide by 7ft high.
* The current window is approximately 1m x 1m.

Job Description

Knock down internal brick wall between the kitchen and dining room
Steel required? ceiling joists run opposite direction to the wall
Make good ceiling, walls floors, plaster where necessary
Block up other internal doorway, plaster and make good.

Advise you visit to quote for works.

Job Description

I have a small (6x6) ground floor store room which is joined to my maisonette but only accessible through an outside door. I would like to get an internal door put in so that so that it can be converted into a laundry room. As part of the job I am looking to get the plumbing and electrics fitted for a washing machine and dryer and some surfaces built in as well as a heater/radiator installed. I would like the room to be fully functional as a laundry/utility room ideally with some storage cupboards. At the moment the room is empty apart from a couple of meters (gas and electric) and a light. I would like the job done some time in the next few months but I can be flexible on dates.

Job Description

What needs to be done:

Move gas mains supply by 1.5m (outside)
Block rear door and small window
Remove brick door surround within new bathroom
Work with drains outside to ensure sufficient drainage from new bathroom. Also move/disguise drain.
Fit bathroom, shower tray, appliances and cupboard
strip out drainage in old bathroom, remove external pipes and fill up holes in wall, direct all new kitchen drainage down one pipe.
build bathroom wall
knock kitchen wall down, repair ceiling
take up floor tiles
lay new quarry tile floor
Use plumber to lines up pipe for new kitchen
plumber second fix
Disconnect current kitchen appliances
remove kitchen window and bricks
Fit French doors

Here are the plans for the completed design, currently the bathroom is where the kitchen will be, the kitchen is in the bottom left corner and there is a corridor where the bathroom will be:

http://picasaweb.google.com/Princejames11/KitchenBathroom#5523765289341382802

Our completion target is the 22nd of Novemeber 2010.

Skills that are required for the project:
Brick Laying
Plumbing
Gas works
Plastering
Electrics

Viewing is recommended prior to quoting, can be available in the day if required. When quoting please supply references and details of recent portfolio.