Conservatories jobs in Willesden, North London

Job Description

Build 25 x 12ft rear conservatory in UVPC. Base needed, quote to include labour and materials

Job Description

Conservatory (On Order)

Build the foundation (4m x 2.5m),
Build 1 wall and plaster (2.5m x 2.5m) and to assemble the conservatory (purchased from http://www.conservatoryland.com/)
Plaster the outside wall of house inside the conservatory (4m)
Tile the floor, paint the walls.
Install light and power fittings
Install a radiator
To move and re position an outside tap.
Job is at WD6 2AB. Please can your quote include all materials, excepting the tiles and radiator.

Job Description

Hello,
We have a leak in our conservatory which we would want to be fixed. At the same time,we are also looking at replacing the plastic roof for a glass roof

Job Description

repair/build.no base needed

Job Description

4m x 4m Edwardian conservatory to be dismantled (Kent) and re-erected (North London). We currently have a smaller (2.7 x 3.7m) wornout conservatoy which we will take down. Base will need to be extended.

Job Description

we have an old lean-to on our victorian terrace with a breeze block part-wall, wood-framed glazing, and a corrogated plastic roof. We would like this replaced. It is only 1.8m x 3.25m, single storey. The wall may not need to come down, the floor is fine and we are willing to take advice on the best materials to use. The location is difficult because there is no rear access and all materials will need to go through the house's narrow hallway. We want fully inclusive, clear quotes before we contract the job.

Job Description

Replacing the current DIY conservatory at the back of our maisonette. Planned work: next spring. Need a quote first.

Job Description

I want written quotation to build a conservatory based on council approved plans

Job Description

Build a small porch extension (approx. 1.5m by 3m).
Perhaps using uPVC, and perhaps with a low retaining wall made of brick.
(Happy to discuss different options).
If you can do uPVC work then we also have some gaps that need fixing in a couple of existing uPVC external doors.

Job Description

The conservatory roof, at present double skin polycarbonate, needs to be replaced with triple skin roofing. ( approx size 5.5m x 3.0m) One wall needs skilled brickwork repairs following structural engineer report. Side access to the site and vehicle run is available.

Job Description

Rectangular on angled roof of ground level conservatory, approx 40cm x 3000cm.

Job Description

I have a build it your self copnservatory that needs to be put up. Base pads already in place. raft and conservatory to be installed.

Job Description

New 3 x 3.5m Victorian upvc conservatory to be fitted on existing dwarf wall. Will be about 6 weeks until new consevatory is delivered and old one cleared so installer required around mid May.

Job Description

Replace wooden window frames & window sill of 4 large (irregular shaped) windows of lean-to conservatory along 1 side of kitchen of an end of terrace house. Repair leaking plastic conservatory roof (if necessary), repair & replaster conservatory wall below windows. Wall approx 5m long x 1.5m high.

Additionally replace damp course in corner of kitchen and repair/replaster corner wall - approx affected area <1 sqm

Ideally work to be done before end April.

Skills: Carpentry, roofing, plastering, damp proofing

Job Description

Replace existing lean to conservatory with modern, lean to, conservatory. Also replace the old metal doors+windows leading from the house to the conservatory with french doors+windows.

Can use existing base for new conservatory. Existing conservatory dimensions are 4500mm wide by 2300mm long and 2465mm in height (can go a little bit higher with new conservatory)

Existing metal patio doors are 1225x1985mm. Windows on the side are 560mm wide

Would like to use Rehau or equally decent windows for both conservatory and french doors