Conservatories jobs in Clapton, East London

Job Description

Build 25 x 12ft rear conservatory in UVPC. Base needed, quote to include labour and materials

Job Description

4m x 4m Edwardian conservatory to be dismantled (Kent) and re-erected (North London). We currently have a smaller (2.7 x 3.7m) wornout conservatoy which we will take down. Base will need to be extended.

Job Description

we have an old lean-to on our victorian terrace with a breeze block part-wall, wood-framed glazing, and a corrogated plastic roof. We would like this replaced. It is only 1.8m x 3.25m, single storey. The wall may not need to come down, the floor is fine and we are willing to take advice on the best materials to use. The location is difficult because there is no rear access and all materials will need to go through the house's narrow hallway. We want fully inclusive, clear quotes before we contract the job.

Job Description

Replacing the current DIY conservatory at the back of our maisonette. Planned work: next spring. Need a quote first.

Job Description

I want written quotation to build a conservatory based on council approved plans

Job Description

footings in, walls built, needs floor levelling,polycarb windows, roof,double doors, rendering, plumbing and electric has been started

Job Description

The porch on my property is currently standard timber frame with single pane windows and timber door.
I would like to upgrade this to double glazing and upvc all round. There is also a slate roof on the porch which would need to be considered in the fitting as it is a slight angle.

Job Description

Build a small porch extension (approx. 1.5m by 3m).
Perhaps using uPVC, and perhaps with a low retaining wall made of brick.
(Happy to discuss different options).
If you can do uPVC work then we also have some gaps that need fixing in a couple of existing uPVC external doors.

Job Description

The conservatory roof, at present double skin polycarbonate, needs to be replaced with triple skin roofing. ( approx size 5.5m x 3.0m) One wall needs skilled brickwork repairs following structural engineer report. Side access to the site and vehicle run is available.

Job Description

My conservatory (Lean to type) has a roof which is made up of a UPVC frame, and wooden struts seperating 5 plastic panes which are about 1.5 m long and make up the roof of the conservatory.

One of the wooden struts is leaking and is rotting. I need two quotes -

1 - to replace the whole roof with something guaranteed for at least 10 years

2 - to replace the rotten strut and leakproof the other struts.

Work would need to be done fairly quickly and competently.

Job Description

I will buy the conservatory -
The ground needs to be prepared properly and the base made up-
So need the brickwork- dwarf wall and all the insides needs to be done plastering etc.
I will also need central heating and radiator and electric points. Laminate flooring also needs to be laid in the conservatory.
In general all the work needed to make a lovely conservatory.

Work needs to be started within the next few days.

Job Description

I have one slipped panel on my conservatory, and would like the other panels secured to ensure they don't slip.

Approx 9 panels (one recently repaired - but the builder didnt think to check them all!)

Looking to be completed on the 22nd Jan before 2pm.

Thanks

Reena

Job Description

I have a full height glass conservatory from Wickes. It is the Victorian shape (50p shape). It is 3.2m x 2.9m & the base is already built. The base just needs screeding. Waltham Abbey area.

Job Description

I am looking for someone who is able to fit a UPVC conservatory 2.5m x 3m ASAP

Job Description

plan to build a 4mx3m conservatory in Edwardian or Gable style.

* The following information was added Saturday, 31st October, 2009 :
Need 600mm brick based.