Chimneys & Fireplaces jobs in Kingston Upon Thames, Surrey

Job Description

I have a ASAP Job, I need my Chim removal Please contact me ASAP

Job Description

Need a fireplace fitter.

I have taken back an old fireplace and need someone to Install a steel insert and firebox using fibreboard block, lay hearth and seal, fix and secure the fireplace surround and backfill insert with vermiculite and rubble to level height and flaunch gather for smoke dispersal and finally make good all internal areas to reduce soot build up.

I have attached a link to the suite I have (48” pine, slabbed granite, solid fuel with a push-in).

http://www.fireplacesareus.co.uk/shop/gallery-lincoln-wood-fireplace-with-lytton-cast-iron-arch.html

Job Description

I need quotes on capping my chimney to stop water/rain leaking down into the fire place. It's not masses amount of water, but is noticable on the fireplace and chimeny breast. I have a mid terrace house.

Job Description

Removal of current Marble Fire Surround and Marble slab where the fire place is located. Installation of new wooden mantle piece (quote required) and cast iron fire (fit only, we are sourcing one but if you have any that are available please let us know). Making good all plasterwork surrounding fire place.
We do not intend to use the fire at this point in time so chimney works are not required.

Job Description

Looking for someone to quote on how much it would cost to fit a wood burner in a newly discovered fireplace [looks like chimney is functional and roof is easily accessible]

Job Description

I have an exposed fireplace that requires a suitable period fireplace to be installed and the hearth retiled. The building is an Edwardian terrace.

Job Description

I have a fireplace currently with a 1930's surround that needs removing, can be taken off whole. then a surround mounted and cast iron insert fitted, current opening is square shaped needs be altered to fit an arch shaped insert, needs fire cement etc, quite deep. bit of plastering around the surround to make good.

Job Description

We need our chimney lined (ideally with a 904 stainless steel flexible liner) and our multi-fuel stove installed - must be able to have the installation HETAS signed off.

There is also a bit of rendering work that needs to be done during/before installation above the stove on the chimney opening.

It is a two storey Victorian pub converted home.

Job Description

Previous fire was boarded over. Have done the messy work of removing old fire back + infill but require a professional to finish the job off.

* Added 16th February, 2013 :
Decorative only

Job Description

A two storey mews building has a brick chimney stack & parapet which is leaning severely due to very poor pointing. Requires either rebuilding or taking down closer to roof level and weatherproofing lowered upper surfaces.

Job Description

1) The pots on the external chimney stack need removing, existing cement removed, pots then need re-bedding, 8 in total.

2) The exposed brick & flashing needs re-pointing
3) The lower rendered part of the stack needs painting in white external paint

Job Description

This is a sloping roof atop a two storey house. The job is straightforward,a few minutes, but reaching the chimney stack less so.

Job Description

“chiminey removal on ground floor and first floor and building support on the loft for the second chiminey...and insuring that the structure of the wall and remaining chiminey is not affected.”

Job Description

Need to bring in new chimney pot on the roof where the old one used to be. At the moment there is a concrete cap that covers the chinmey, so this will need to be removed to open up the chimney and reinstate the chimney pot. There is access from top floor flat.

Job Description

1 insert with hearth and surround
1 combination fireplace with hearth
Awaiting delivery for both. Gas pipe in but may need moving before new wooden floor is installed.