Chimneys & Fireplaces jobs in Banstead, Surrey

Job Description

Need a fireplace fitter.

I have taken back an old fireplace and need someone to Install a steel insert and firebox using fibreboard block, lay hearth and seal, fix and secure the fireplace surround and backfill insert with vermiculite and rubble to level height and flaunch gather for smoke dispersal and finally make good all internal areas to reduce soot build up.

I have attached a link to the suite I have (48” pine, slabbed granite, solid fuel with a push-in).

http://www.fireplacesareus.co.uk/shop/gallery-lincoln-wood-fireplace-with-lytton-cast-iron-arch.html

Job Description

I need quotes on capping my chimney to stop water/rain leaking down into the fire place. It's not masses amount of water, but is noticable on the fireplace and chimeny breast. I have a mid terrace house.

Job Description

Removal of current Marble Fire Surround and Marble slab where the fire place is located. Installation of new wooden mantle piece (quote required) and cast iron fire (fit only, we are sourcing one but if you have any that are available please let us know). Making good all plasterwork surrounding fire place.
We do not intend to use the fire at this point in time so chimney works are not required.

Job Description

Looking for someone to quote on how much it would cost to fit a wood burner in a newly discovered fireplace [looks like chimney is functional and roof is easily accessible]

Job Description

Hi there, need a stove fitting into existing fireplace. All prep work done and chimney swept and certified. Have stove, pipe, register plate and flue liner. Just need skilled fitter.

Job Description

I have a fireplace currently with a 1930's surround that needs removing, can be taken off whole. then a surround mounted and cast iron insert fitted, current opening is square shaped needs be altered to fit an arch shaped insert, needs fire cement etc, quite deep. bit of plastering around the surround to make good.

Job Description

Previous fire was boarded over. Have done the messy work of removing old fire back + infill but require a professional to finish the job off.

* Added 16th February, 2013 :
Decorative only

Job Description

I need my old and not working gas fire to be taken out and replaced with a new one. Ideally old one removed, then some advice as to best replacement model to get, and once purchased to have the new one fitted. Residential flat in Whyteleafe, Surrey.

Job Description

two chimneys which need checking, sweeping & possibly relining. Woodburner to be installed in one and 90cm stove in the other. If you can also take out the old gas fires and do the necessary amends to the fireplace hole then that would be great!

Job Description

1 insert with hearth and surround
1 combination fireplace with hearth
Awaiting delivery for both. Gas pipe in but may need moving before new wooden floor is installed.

Job Description

Erect scaffolding to both chimney breasts
Rake out mortar joints & re-point
Chop out defective bricks to stacks & relace using similar coloured stock
Check & carry out any necessary repairs to the flaunching
Remove scaffolding
Leave site clean & tidy

Job Description

The surround is in place I need a gas safe registered person to come and fit the actual fire. Gas pipe also in place ready.

Job Description

It seems that chimney breasts have been removed and adequate support has not been provided. Looking for someone to have a look and give a quote on fitting a pair of gallows brackets.

Job Description

I require a gas fire, limestone surround, cast iron insert and granite hearth to be fitted

Job Description

1935 terraced house in Sutton. requires chimney lining to install stove burner