Central Heating jobs in Longfield, Kent

Job Description

Hot water not working possibly a fuse gone?

Job Description

I am looking for a corgi registered plumber to quote for a power flush. I have been advised this is why my boiler is not working efficiently. I have 9 radiators in the house. I have already been quoted £350 so if you think you can do a good job for less than that can you get in touch.

Job Description

Hi I would like a couple of jobs done, these are:
1. Move radiator location and replace old radiator with new one. (Aprox. 3.5 metres)
2. Move combination boiler 1 metre

Job Description

Supply and fit new a rated boiler, Worcester greenstar or similar standard suitable for 3 bed 1 bath house.

Job Description

I have built a self contained smallish building (55 square meters) in my back garden, I am looking to put the first fix plumbing (bathroom and kitchen) plus a full heating system in. The heating would need an LPG boiler and all pipework, radiators are already bought

Job Description

Service of Baxi back boiler.

Boiler working ok but last known service took place 2010.

Job Description

Have taken a rad off the wall but whole system needed draining down as no valve present on return side. Cant re-fill system, have tried everything but wont re-fill and the way it has been done up in the loft i have never seen before, gravity fed system but no seperate expansion tank, its all done of the main cold tank, vents as well and both my normal plumbers have said system has had it, all needs to be re done. They are both booked up for at least a month so i am looking to get someone in to suggest some ideas and give the cusomer a few quotes, obviously the quotes will go to the customer as i am just acting as a middle man. The couple are quite old and quite poorly and because i cant re-fill the system they have been without hot water and central heating yesterday and all today so im looking to get quotes done asap. I will show everyone who is shortlisted round so you can get an idea of the layout but in terms of the best system to put in i have no idea, my knowledge is only limited.

Job Description

I need most of the radiator valves on my central heating system replaced. There are 13 rads and 2 heated towel rails. All but 2 or 3 of the rads/rails need valves replacing. Would want system rebalanced on completion of work.

Job Description

Remove existing radiator and move pipework to install new designer radiator. Existing radiator standard white type, circa 3 ft long. New radiator is 300mm wide and 1500mm tall. This will be set approx two foot to the right of the existing radiator so pipework will need to be moved across to fit. Wall is insulated exterior wall with plasterboard finish.

Job Description

Looking to replace 4 radiators in the house due to poor performance, possibly full of sludge & external rusting. Small double in kitchen, large single in bedroom, large double in lounge & a small double in lounge. The small double was actually removed last year as it fell off wall so a bit of pipework will be needed too. Happy to get you round for quote or feel free to give a ballpark cost. Will need you to measure required radiator sizes, supply & fit, possibly including TRV's or new valves as appropriate & then balance system as appropriate. Also have a radiator in conservatory which was spurred off a radiator in Dining Room. It never really gets hot so would like a better solution if possible on your advice.

Job Description

Wall is approx 1m long which is to be knocked down. Also rearrange a few gas pipes

* Added 10th February, 2013 :
Internal wall is approx 1.4m in length and is load bearing. Trying to upload a photo which isn't working.

Job Description

I currently have an old hot air blowing system and am interested in replacing it with a modern, very energy efficient boiler and radiators.
Visible pipe work to be kept to a minimum

Job Description

Boiler to be moved approx 3 feet, toilet to be taken out and existing plumbing for washing machine and dishwasher to be checked

Job Description

changing 2 radiators + fitting wirless thermostat for a combi boiler

Job Description

Dear Sirs,

My Vaillant Ecomax series condensing boiler which for the avoidance of doubt, works perfectly, needs servicing. I would prefer a local specialist due to the size of the work and associated travel costs.

Please let me have a quote.

Kind regards,

Alexander