Central Heating jobs in Aylesbury, Buckinghamshire

Job Description

My boiler is currently show no pressure when I add water it charges then drops back down again

* Added 29th December, 2012 :
Situation was as above as of last night this morning there was a very small amount of pressure showing in the system, as opposed to the needle resting on the bottom. I charged the system and its now running. Investigation work needed to identify failing component. However not as urgent as, for now, we have heating

* Added 7th January, 2013 :
Re-opened issue has not gone away am just re-charging the boiler then the pressure goes down agaim

Job Description

Hi, my boiler is working for water but not coming on for heating. The thermostat ticks just about where it should do in order to come on, but no joy! Can anyone out there help before I get cold??

Job Description

We live in a 4 bedroom house that has been extended a few times and rads added. Last year, we had the whole system cleaned out and a magnaclean added and all the rads seemed to be working. Now many of the rads are cold, even on maximum. The initial job is to come out and try and rebalance the system and service the boiler. It is a Gloworm

Job Description

Gas central heating systen with Worcester Greenstar 24Ri boiler was installed in February 2009 with the heating system controlled by a Drayton Digistat RF3 wireless system. This was working well until a few weeks ago when the heating started to switch itself off when heating was called for or not coming on when it should. I have managed to get it going by repeatedly lowering and raising the temperature until the system clicks in. The themostat has been moved around and new batteries installed - all to no avail. The system now seems to have stopped working altogether and no amount of fiddling with it seems to have any effect. I get the feeling that the system is clapped out as it is older than the rest of the heating system. It might be repairable or it might need a more modern replacement - I would welcome advice on this.

Job Description

Servicing of a Baxi powered flue solo boiler

Job Description

We have 4 missing radiators (pipework is all in situ). We need someone to measure up for, purchase and fit all 4 radiators, 2 downstairs and 2 upstairs. It may be that one or two of the valves also need replacing.

Job Description

Hi, hope someone can help. Basically bought a house to renovate, mortgage company squeeze at last minute and now lack of work means funds are limited (like everyone) but really need a new boiler as old one is completely knackered. House is a building site as electrics are being done so easy access to under floorboards in everyroom

Old boiler is about 30 yrs old, no seal round edge, black marks on wall, keeeps getting air locked - so turned it and gas off. Current system is open vented standard setup with boiler in kitchen

We are currently using an immersion off the hot water cylinder

Ideally and if possible to keep outgoings down I would like to do as much as possible to assist, in terms of removing old pipes, chasing kitchen floor to run larger capacity gas pipe, no need to make good afterwards, anything else you are happy for me to do really! If possible we would also just like to have the hot water sorted with new boiler as we would really like to install wet underfloor heating when funds allow but need hot water now - will explain when you contact me

Please call me ASAP as we are looking to get this done within next couple of weeks

Thanks,

Nick

Job Description

The boiler is a Potterton Suprima 80L. The heating system comprises conventional steel panel radiators (8 double and 6 single of various sizes) - most fitted with thermostatic valves. Gas fire is a Portway Euroglow Inset Gas Coal Fire (Model no. EB16NG or EB16P). The Megaflo is a CL250HE and may require re-charging. Everything is believed to be about 9 years old and with the exception of the gas fire was serviced 2 years ago.