Carpentry & Joinery jobs in Sevenoaks, Kent

Job Description

Old straight run staircase to be removed from centre of house to be replaced with a new one (already made or reuse old one if possible) in the same place but opposite direction. The new one (or old one slighly amended) to have a flared bottom step.

Job Description

As per job title. Alcoves about 1.4m wide, 0.4m deep and 2m tall.

Other carpentry jobs include the building, painting and fitting of a window seat and a radiator cover + storage unit.

MDF use likely.

Job Description

To be fitted from the entrance hall to loft (Bungalow)

Job Description

I need the skirting boards removed and replaced in the living room. It is only a small job so i would apprecaite someone friendly and efficient to help me finally complete this room.

Job Description

NEWEL POST TO FIT HAND RAIL BASE RAIL SPINDLES
ALSO NEED A KITE FITTED TO BOTTOM RUN

Job Description

I have 2 to 5 doors that need to be either replaced or repaired

Job Description

Our parrot has chewed the top part of a cupboard (all along the top!) I am looking to have it rubbed down, filled and coloured antique pine. It is not an expensive piece of furniture, but do want to keep it as it is the top part of my tank. My husband is useless at stuff like this, but a very good electrician! (in situ - would be a pain to move) or a week day after the 1st March. Despite the postcode, live on the outskirts of New Ash Green

Job Description

I would like some floor to ceiling custom made wardrobes for our bedroom. The space available is 2.80m width, and 2.27 height, with room to go around the corner- see photograph. I would like some advice/suggestions regarding the design. Ideally I want the wardrobes finished in off white/ cream colour- I am open to options regarding painted or veneer finish. Please let me know a rough estimate of cost prior to visiting for a full quote.

Job Description

To hang 9 new doors and two new double-doors.

Job Description

Supply and fit a cupboard door 85cm x 50 cm. Preferably to match existing victorian panelled doors.
Repairs to original staircase handrail.

Job Description

Have 2 old doors to remove and 2 new doors that need handles / locks / hinges etc to be fitted for bedrooms.

Job Description

To remove old balustrade and fit new balustrade on landing. Approximate measurements 3m with 1m turn. Would like a quote for a traditional balustrade and a quote for glass ie Richard Burbidges' 'Fusion' range. Or would be open to any other suggestions.

Job Description

All doors and furniture on site.

Job Description

Cutting and fitting of timber worktop required to newly installed kitchen. U shaped kitchen with approximately 9 m of worktop. Need cutting for sink and hob etc. Looking for quote.

Job Description

I need someone who can cut a seamless 45 degree on two of my laminate worktops to create a 90 degree right hand corner. Someone who is competent and has a worktop jig and router as I specifically do not want a piece of trim down the join.