Bathroom Fitting jobs in Reading, Berkshire

Job Description

I have a walk-in shower that has some water damage on current polished plaster walls.
I'm looking to have the walls and tray retiled

Job Description

Bathroom is 146cm x 227cm (4ft9"x7ft5")
Need to replace subfloor due to water leak with plywood
Then tile wall and floor with 300x600mm tiles
Install new bathtub / sink/ toilet and mirror

Job Description

I have an Aqualisa Shower which has stopped working the controller has been replaced by Aqualisa and apparently the problem is with the wiring which is too short so the job will probably involve removing a tile or two and clearing a length of wire from the wall re tiling and re fixing the shower controller.
I also have another shower door that has come off its runners and may need some new mechanism to stop it knocking anyone out as it falls inwards every time it is slid open.

Job Description

Refurb bathroom - remove existing tiles, bath sink etc..., make floor good for tiling, fit cement board in appropriate areas, build shelf area to hide pipe work, repair ceiling and fit new spot lights, fit new shower bath and screen, fit new toilet and sink, tile floor and walls, fit shower mixer taps and bath filler kit, fit water pump, paint ceiling and door.
Bathroom is approx. 236cm x 202cm x 237cm

Job Description

Complete refit of bathroom as 1st phase of renovation. Bathroom measures 1800mm x 1800mm. Works to include tiling, flooring and change of layout. Quote to include labour and some materials. Bathroom suite already sourced.

Job Description

We have a very small bathroom which is 1.6 by 1.8m. We want to do I direct swap for new bath but swap sink and toilet location - this would involve remove 2 floorboards to sink soil pipe. We also want a direct swap of radiator for towel rail and a shower to be put up above bath ( has seperate thwrmo valve so not linked to bath). We want whole bathroom re tiled but no border and medium sized tceramic tiles, including bath panel. Also want shower screen and bath cabinet put up.

Job Description

Replace faulty doors with new.

Would like to change the tray and doors from quadrant shape to square.

Job Description

We have a small en-suite, but we want it re-tiled, a new shower but keep the original toilet and sink.

Job Description

Remove and replace small basin with new one

Job Description

Shower was fitted about a year ago. The grout between tiles has cracked and water got behind tiles. I have removed some tiles to see extend of water ingress. The water ingress was not that bad, but to prevent this from happening again I would like to replace the plasterboard behind the tiles, do new tiling and use good quality flexible grout.
The shower cubicle will have to be removed and fitted again.
The tiled area is only for the shower area. The two wall sections are 880 x 2200mm and 790 x 2200mm

Job Description

After building an extension we now wish to fit an en-suite into a completely empty room. There is no lighting or pipework currently visible in the room. The electrics and the plumbing are in the loft and are ready to be fitted.

We are looking at getting a fairly basic suite (can purchase from somewhere like bathstore). We need a shower unit (approx 1200mm), toilet, sink and extractor fan.

Job Description

Please can you provide a quote for installing and tiling a new bathroom.
I would require the following:
1. Remove existing bathroom suite.
2. Fully fit all sanitary ware in new position.
3. Plaster skim ceiling – only if required.
4. remove old radiator and fit towel warmer in its place.
5. Fit low voltage ceiling spotlights (5).
6. Line floor with 9mm plywood.
7. Fully tile wall and floor area of approx. 20 sq.m.
8. Fit tiled boxing at end of bath.
9. Make all necessary pipe-work alterations and additions.
10. Supply electrics and fit supplied mixer shower on wall.

Please note, No skip will be required as all waste will be removed by myself, this request is just to fit and tile a new bathroom, with the exception of the new pipework, all fittings will be supplied.
Thank you

Job Description

Bathroom fitting and tiling

Job Description

Toilet, sink and shower fitted, tiling all round and paint door and ceiling.

Job Description

I have a small bathroom approx 6x7 ft that is currently tiled on 3 walls to 3/4 height.
I have already sourced the suite, taps, tiles and radiator, so it will just be to remove the old and replace with the new, except the tiling will be full height on all walls.